W-type hydraulic ejector (water pump) installation diagram and precautions

W pump (water pump) correct installation or not only affects the operation of equipment, but also affect the life of water pump. Below, Xiaobian introduced to you the W-type hydraulic ejector (water pump) installation diagram and precautions, I hope you can help to everyone. W-type hydraulic ejector (water pump) Installation diagram and precautions Water pump installation Notes: (1) from the water pump to the ejector of cold water into the pipeline, pipe fittings should be minimized, so that the resistance loss is reduced. (2) Vertical drainage pipe without bend, such as must be twists and turns, the angle of no more than 45 degrees, commonly used 30 degrees, and turning no more than twice. (3) The interface requirements of strict, to avoid leakage. (4) Installation, the user according to diffuser export pipe diameter pipe with a section for tail pipe, the length should generally be more than 2 meters, but not into the circulation pool. (5) fault: the degree of vacuum is not reached, the reason: the installation of pipe connection leakage, nozzle plug, pump flow pressure shortage, vacuum gauge failure. The above is the W-type hydraulic ejector (water pump) installation diagram and precautions related to the introduction, the operator during installation must pay special attention to the above matters, so as not to damage the water pump, causing unnecessary losses, while avoiding Inconvenience to work Further Reading: pump valve pipe fittings Exhibition 2016 Exhibition of Information Industry, Internet (Xiamen) Technology Co., Ltd. Author: Asian pumps Network Editor: Small L (QQ / micro-channel:) http://beng.liuti.cn/ (Service Hotline:)