Reasons and Improving Methods of Serious Wear of Excavator Hydraulic Pump

Excavator hydraulic pump serious wear and tear on the excavator has a fatal impact, excavators appear such problems must be promptly resolved. Repair excavator hydraulic pump from the following three points to find the cause of the malfunction: (1) Check the boom cylinder internal leakage situation is the easiest way is to boom up to see if there is a clear free fall. If the whereabouts of obvious removal of fuel tank inspection, seals have been worn should be replaced. (2) check the pilot valve to clean the safety valve, check whether the spool wear, such as wear and tear should be replaced. If the safety valve is still installed after the change, then check the control valve spool wear, the use of the gap limit is generally 0.06MM, serious wear and tear should be replaced. (3) measuring the pressure of the hydraulic pump If the pressure is low, then make adjustments, the pressure is still not adjustable, the serious wear and tear of the hydraulic pump. First, the general cause of the boom can not be carried with the main reasons for lifting: 1, excavator hydraulic pump serious wear and tear at low speed pump leak serious; high-speed operation, the pump pressure slightly increased, but due to pump wear and internal leakage , Volumetric efficiency decreased significantly, it is difficult to achieve the rated pressure. Hydraulic pump work for a long time has exacerbated the wear and tear, oil temperature, resulting in wear and tear of hydraulic components and seals aging, damage, loss of sealing ability, hydraulic oil deterioration, and finally lead to failure. 2, the selection of hydraulic components unreasonable Boiler specifications for the 70/40 non-standard series, the seals are non-standard parts, high manufacturing costs and seal replacement inconvenience. Boom cylinder bore is small, the system is bound to set high pressure. 3, the hydraulic system design unreasonable control valve and full hydraulic steering gear for a single pump in series, safety valve setting pressure points 16MPA, while the hydraulic pump rated working pressure is 16MPA. Hydraulic pump often at full load or prolonged overload (high pressure) work, and the system has a hydraulic impact, long-term oil does not change, the hydraulic oil contaminated, exacerbating the hydraulic pump wear and tear, resulting in hydraulic pump shell burst (was found Such failure). Second, the improvement and effect (1) to improve the design of hydraulic system After several demonstrations, and finally the use of advanced priority valve and load sensing hydraulic steering gear form. The new system can give priority to the distribution of traffic in accordance with the steering requirements, regardless of the size of the load, the steering wheel speed can ensure adequate supply of oil, the remaining part can be fully supplied to the working device circuit, thus eliminating the power supply due to excessive steering oil supply Loss, improve the system efficiency, reducing the working pressure of the hydraulic pump. Reduce the hydraulic excavator serious wear and tear. (2) Optimize the design of boom cylinder and hydraulic pump to reduce system working pressure. Through optimization calculation, the boom cylinder adopts standard series 80/4. Hydraulic displacement from 10ML / R increased to 14ML / R, the system set pressure of 14MPA, to meet the boom cylinder lifting force and speed requirements. (3) to strengthen the daily inspection and maintenance During the use should also pay attention to the proper use and maintenance of the loader, regularly add or replace hydraulic oil, hydraulic oil to maintain cleanliness, and strengthen routine inspection and maintenance. In order to avoid serious excavator hydraulic pump wear.